EPC Server - Your Resource for Engineering, Procurement, and Construction Support
Log In Registration To Do List Online Analysis Developers Partnership About EPC Server

You can select the following headers for your output file. Custom headers can be developed by all registered users who are logged on.




Make a New Header
This application is not certified View Bug Report Submit Bug


Pipe Support - Restraint



Complete the following input



Input the Calculation number
Input the Pipe Support ID
Input the Standard Component ID
Input the Stress Calculation which derived the support loads
Input the angle alpha in degrees
Input the angle beta in degrees(-10o to 10o
Input the dimension d in inches
Input the dimension a1 in inches
Input the dimension a2 in inches
Input Applied Load along axis of strut in lbs
Input Support Stiffness Requirement in Lbs/in
Select Pipe Diameter
Select the Section for Local Bending Check
Input the desired margin expressed as a percentage (e.g. 25 for a 25% margin)




Clicking above will result in a $5.00 charge to your account




Try Our Message Board


Bringing Efficiency to the Construction Industry
EPC Server.com
Copyright © 2001,2002, EPCServer.com All rights reserved. All content in this site is provided 'as is' and no warranty is given as to the accuracy or suitability of any part hereof. No liability will be accepted for any direct or consequential losses, howsoever caused, following the use or misuse of any advice or information, real or implied, provided by this site.