EPC Server - Your Resource for Engineering, Procurement, and Construction Support
Log In Registration To Do List Online Analysis Developers Partnership About EPC Server

You can select the following headers for your output file. Custom headers can be developed by all registered users who are logged on.




Make a New Header
This application is not certified View Bug Report Submit Bug





PANEL STIFFENER


Note: this analysis does not check for maximum spacing of stiffeners. A plate buckeling analysis should be performed.

Input the Panel Thickness - t in inches
Input the distance between stiffeners - W in inches
Input the distance between center of gravity of panel and center of gravity of stiffener - d in inches
Input the Cross Sectional Area of Plate in in2
Input the Cross Sectional Area of the Stiffener in in2
Input the Moment of Inertia of the stiffener in in4
Input the height of the panel in inches
Input a uniform load on the panel in lbs/inch (enter 0 if none)
Input a maximum load on bottom of panel if linearly increasing load (enter 0 if none)
Input a Concentrated Load on the Panel in lbs (enter 0 if none)
Input the distance from the top of the panel where a concentrated load is applied in inches (enter 0 if none)
Input the thickness of the stiffner where it joins with the plate in inches (enter 0 if none)



Clicking above will result in a $5.00 charge to your account





Try Our Message Board


Bringing Efficiency to the Construction Industry
EPC Server.com
Copyright © 2001,2002, EPCServer.com All rights reserved. All content in this site is provided 'as is' and no warranty is given as to the accuracy or suitability of any part hereof. No liability will be accepted for any direct or consequential losses, howsoever caused, following the use or misuse of any advice or information, real or implied, provided by this site.