EPC Server - Your Resource for Engineering, Procurement, and Construction Support

USER IS NOT LOGGED IN

BUILD YOUR CALCULATION HEADER

You may build a new STANDARD header for your calculations or fill in text for saved STANDARDS by selecting a STANDARD from the list below:

Fill In Fields of a Standard Header

I want to delete some Headers

Develop a New Standard Header

Building your Calculation Header involves a series of screens requiring input by following the prompts. The steps involve the following:

Input the number of rows - Include all rows even rows which will remain blank
For each row input the number of cells.
Next set the height of the rows in pixels.
Next set the width of each cell in each row as a percentage of the width of the page.
For Each Cell specify the text to be included
Next set the alignment in each cell for the text
Set the text size by using + or - a value to increase or decrease font size.
Select the cells which should be shaded.
An interum sheet will be shown where you can print it. Revisions can be made in the next screen.
The next screen permits you to designate which cells require text input when using the cover sheet
And the final screen permits you to save the coversheet under your designated file name

Note that your browser has the ability to set margins and print in portrait or landscape.

When you log in and access our analysis section you will be prompted to decide if you wish to use the header. Make sure you also access our BUILD CALCULATION COVER SHEETS as well.

Try Our Message Board

Bringing Efficiency to the Construction Industry EPC Server.com

Copyright © 2001,2002, EPCServer.com All rights reserved. All content in this site is provided 'as is' and no warranty is given as to the accuracy or suitability of any part hereof. No liability will be accepted for any direct or consequential losses, howsoever caused, following the use or misuse of any advice or information, real or implied, provided by this site.